Start with the homes. Hansville was a fishing resort and summer cabin community before it became a retirement destination. The housing is a mix of 1950s and 60s beach cabins that have been winterized, 1970s Driftwood Key homes on the canals, 1980s and 90s view homes on the bluffs, and a scattering of newer custom builds. Roughly a third of the homes are second homes that sit empty for stretches, which is its own plumbing risk. It is a little over an hour from Port Orchard, the longest drive we make inside Kitsap County to Hansville, a run we make often enough to know the roads, the water districts and the quirks of the housing.
Why backflow preventer installation is a little different in Hansville
Water purveyors serving Hansville run annual backflow testing programs, and the notices they send often leave homeowners unsure what device they actually need. We call the district, confirm the hazard classification, and install exactly what they will accept.
Digging and draining in Hansville depend on the soil. Hansville occupies the northern tip of the Kitsap Peninsula, with Puget Sound on one side and Hood Canal on the other. Point No Point is a low sandy spit with a very high water table; Driftwood Key's canal lots are at sea level; the bluff neighborhoods sit on glacial till and clay above the beaches. Salt air and brackish groundwater corrode buried steel fast.
Local conditions that affect backflow preventer installation in Hansville
Local conditions shape the work. In Hansville: Extended outages stopping septic pumps, wells and sump pumps at once
Newer homes in Hansville with residential fire sprinklers frequently have a double check assembly in the garage or crawlspace that nobody has looked at since the house was built. We inspect, test-coordinate and replace those when they fail.
In Hansville specifically, one issue comes up more than most: Frozen and burst pipes in second homes left unheated through a cold snap
Commercial properties in Hansville, from restaurants to car washes to medical offices, usually need an RPZ on the service and sometimes on individual equipment. We install them above grade with proper discharge so the relief port does not flood a floor.
Signs Hansville homeowners call us for backflow preventer installation
Worth a call
- Your property has both a private well and a city water connection
- An old assembly is corroded, the shutoffs will not close, or the test cocks are seized
- A home inspector or county inspector flagged a cross-connection
- The brass body cracked in a winter freeze
- Your water district sent a notice requiring a backflow assembly or an annual test
How we handle backflow preventer installation in Hansville
When a Hansville homeowner books backflow preventer installation, the job unfolds as figure out what the purveyor wants, site check and flat quote, install with testable access, initial certification, then record and remind, and you can watch and ask questions the whole way.
Read the full step-by-step for backflow preventer installation →
Hansville neighborhoods and areas we serve
Buck Lake area, Eglon and the streets between them see us regularly, as do the properties near Norwegian Point County Park and Buck Lake County Park. If you are in Hansville, you are covered.
Backflow Preventer Installation questions from Hansville
Can you winterize a backflow assembly in Hansville?
Yes. We add drain ports and blowout access during installation and can retrofit them to existing devices, and we offer insulated enclosures for assemblies exposed to the Kitsap County east wind.
Do you handle the paperwork for the Hansville water district?
We coordinate the initial certification test and make sure the report reaches your purveyor. You get photos and device details for your own records.
Is a permit needed to install a backflow preventer in Hansville?
Usually a plumbing permit is required, and the purveyor needs the installation and test report. We take care of both as part of the job.
Which water districts in Hansville require backflow preventers?
Every public water purveyor serving Hansville runs a cross-connection program under Washington's drinking water rules. If you have irrigation, fire sprinklers, a boiler or a well on the property, expect a requirement.
Why is water coming out of my backflow device?
If it is an RPZ, the relief port is doing its job because a check valve is fouled or failed, or because of pressure fluctuation on the street. Debris after a water main repair is a common cause. It needs service, but it is not an emergency unless it will not stop.
Greg started this company to do plumbing the way he would want it done at his own house: show up when promised, explain the options, and leave the place clean. That is what Hansville homeowners can expect from us.